Spring Clamps are used to clamp parts with low force without obstructing the measurement access.

The kinematic fixture plate can be placed in exactly the same position without the need for manual alignment. It is placed on top of a pre-mounted kinematic base plate.

Single Unit Filter / Dryer system maintains accuracy of the CMM while reducing downtime and expensive repairs. The system works by drying the air and removing oil and other contamination before entering CMM airlines and air bearings.

The Single Unit CMM Filtration System maintains accuracy of the CMM while reducing downtime and expensive repairs.

Stylus changer port for scanning sensors HP-S-X5, HP-S-X5 HD, LSP-S2 and LSP-S4.

TKJ angular adapter 90° made of aluminium and stainless steel

TKJ to M8 adapter made of carbon fibre and stainless steel with a length of 450 mm

Calibration sphere (Ø25.4 mm) for calibration of Laser Scanner probes for machine tools and CMM.

Stylus changer port for scanning sensors HP-S-X1S, HP-S-X1H and HP-S-X1C.

Spring Clamps are used to clamp parts with low force without obstructing the measurement access.

The twin Vee block can be used with the flexible vice to position and hold parts in place. It can also be used to centre parts diagonally in combination with the single Vee.

The M4 adjustable cone made of Delrin® is shaped to reduce direct contact with delicate parts and can be adjusted in height.

The hinge pivot is used to set up two pillars at variable angles. This gives high flexibility in setting up larger fixtures.

Standoff made of aluminium, with M8 thread. It is used for lifting parts or for attaching other Swift-Fix components to achieve the required height.

The lateral clamp comes with a tapered pressure button for easy positioning against a location face.

Pillars are used to horizontally mount Swift-Fix elements. It adds both stability and height and can be fixed to either the base plate or the machine table.

Standoff made of aluminium, with M8 thread. It is used for lifting parts or for attaching other Swift-Fix components to achieve the required height.

This fixture base plate can be connected side-by-side with other base plates with the same size. M8 holes and alpha numeric identification allowing fixtures to be re-built easily.

The standoff support cone made of Delrin® has a flat surface for the damage-free positioning of parts.

Cap screws are used to mount Swift-Fix components on the base plate.